/*
 * SSI to SD card adapter.
 *
 * Copyright (c) 2007-2009 CodeSourcery.
 * Written by Paul Brook
 *
 * This code is licensed under the GNU GPL v2.
 *
 * Contributions after 2012-01-13 are licensed under the terms of the
 * GNU GPL, version 2 or (at your option) any later version.
 */

#include "qemu/osdep.h"
#include "sysemu/block-backend.h"
#include "sysemu/blockdev.h"
#include "hw/ssi/ssi.h"
#include "hw/sd/sd.h"
#include "qapi/error.h"

//#define DEBUG_SSI_SD 1

#ifdef DEBUG_SSI_SD
#define DPRINTF(fmt, ...) \
do { printf("ssi_sd: " fmt , ## __VA_ARGS__); } while (0)
#define BADF(fmt, ...) \
do { fprintf(stderr, "ssi_sd: error: " fmt , ## __VA_ARGS__); exit(1);} while (0)
#else
#define DPRINTF(fmt, ...) do {} while(0)
#define BADF(fmt, ...) \
do { fprintf(stderr, "ssi_sd: error: " fmt , ## __VA_ARGS__);} while (0)
#endif

typedef enum {
    SSI_SD_CMD,
    SSI_SD_CMDARG,
    SSI_SD_RESPONSE,
    SSI_SD_DATA_START,
    SSI_SD_DATA_READ,
} ssi_sd_mode;

typedef struct {
    SSISlave ssidev;
    ssi_sd_mode mode;
    int cmd;
    uint8_t cmdarg[4];
    uint8_t response[5];
    int arglen;
    int response_pos;
    int stopping;
    SDState *sd;
} ssi_sd_state;

/* State word bits.  */
#define SSI_SDR_LOCKED          0x0001
#define SSI_SDR_WP_ERASE        0x0002
#define SSI_SDR_ERROR           0x0004
#define SSI_SDR_CC_ERROR        0x0008
#define SSI_SDR_ECC_FAILED      0x0010
#define SSI_SDR_WP_VIOLATION    0x0020
#define SSI_SDR_ERASE_PARAM     0x0040
#define SSI_SDR_OUT_OF_RANGE    0x0080
#define SSI_SDR_IDLE            0x0100
#define SSI_SDR_ERASE_RESET     0x0200
#define SSI_SDR_ILLEGAL_COMMAND 0x0400
#define SSI_SDR_COM_CRC_ERROR   0x0800
#define SSI_SDR_ERASE_SEQ_ERROR 0x1000
#define SSI_SDR_ADDRESS_ERROR   0x2000
#define SSI_SDR_PARAMETER_ERROR 0x4000

static uint32_t ssi_sd_transfer(SSISlave *dev, uint32_t val)
{
    ssi_sd_state *s = FROM_SSI_SLAVE(ssi_sd_state, dev);

    /* Special case: allow CMD12 (STOP TRANSMISSION) while reading data.  */
    if (s->mode == SSI_SD_DATA_READ && val == 0x4d) {
        s->mode = SSI_SD_CMD;
        /* There must be at least one byte delay before the card responds.  */
        s->stopping = 1;
    }

    switch (s->mode) {
    case SSI_SD_CMD:
        if (val == 0xff) {
            DPRINTF("NULL command\n");
            return 0xff;
        }
        s->cmd = val & 0x3f;
        s->mode = SSI_SD_CMDARG;
        s->arglen = 0;
        return 0xff;
    case SSI_SD_CMDARG:
        if (s->arglen == 4) {
            SDRequest request;
            uint8_t longresp[16];
            /* FIXME: Check CRC.  */
            request.cmd = s->cmd;
            request.arg = (s->cmdarg[0] << 24) | (s->cmdarg[1] << 16)
                           | (s->cmdarg[2] << 8) | s->cmdarg[3];
            DPRINTF("CMD%d arg 0x%08x\n", s->cmd, request.arg);
            s->arglen = sd_do_command(s->sd, &request, longresp);
            if (s->arglen <= 0) {
                s->arglen = 1;
                s->response[0] = 4;
                DPRINTF("SD command failed\n");
            } else if (s->cmd == 58) {
                /* CMD58 returns R3 response (OCR)  */
                DPRINTF("Returned OCR\n");
                s->arglen = 5;
                s->response[0] = 1;
                memcpy(&s->response[1], longresp, 4);
            } else if (s->arglen != 4) {
                BADF("Unexpected response to cmd %d\n", s->cmd);
                /* Illegal command is about as near as we can get.  */
                s->arglen = 1;
                s->response[0] = 4;
            } else {
                /* All other commands return status.  */
                uint32_t cardstatus;
                uint16_t status;
                /* CMD13 returns a 2-byte statuse work. Other commands
                   only return the first byte.  */
                s->arglen = (s->cmd == 13) ? 2 : 1;
                cardstatus = (longresp[0] << 24) | (longresp[1] << 16)
                             | (longresp[2] << 8) | longresp[3];
                status = 0;
                if (((cardstatus >> 9) & 0xf) < 4)
                    status |= SSI_SDR_IDLE;
                if (cardstatus & ERASE_RESET)
                    status |= SSI_SDR_ERASE_RESET;
                if (cardstatus & ILLEGAL_COMMAND)
                    status |= SSI_SDR_ILLEGAL_COMMAND;
                if (cardstatus & COM_CRC_ERROR)
                    status |= SSI_SDR_COM_CRC_ERROR;
                if (cardstatus & ERASE_SEQ_ERROR)
                    status |= SSI_SDR_ERASE_SEQ_ERROR;
                if (cardstatus & ADDRESS_ERROR)
                    status |= SSI_SDR_ADDRESS_ERROR;
                if (cardstatus & CARD_IS_LOCKED)
                    status |= SSI_SDR_LOCKED;
                if (cardstatus & (LOCK_UNLOCK_FAILED | WP_ERASE_SKIP))
                    status |= SSI_SDR_WP_ERASE;
                if (cardstatus & SD_ERROR)
                    status |= SSI_SDR_ERROR;
                if (cardstatus & CC_ERROR)
                    status |= SSI_SDR_CC_ERROR;
                if (cardstatus & CARD_ECC_FAILED)
                    status |= SSI_SDR_ECC_FAILED;
                if (cardstatus & WP_VIOLATION)
                    status |= SSI_SDR_WP_VIOLATION;
                if (cardstatus & ERASE_PARAM)
                    status |= SSI_SDR_ERASE_PARAM;
                if (cardstatus & (OUT_OF_RANGE | CID_CSD_OVERWRITE))
                    status |= SSI_SDR_OUT_OF_RANGE;
                /* ??? Don't know what Parameter Error really means, so
                   assume it's set if the second byte is nonzero.  */
                if (status & 0xff)
                    status |= SSI_SDR_PARAMETER_ERROR;
                s->response[0] = status >> 8;
                s->response[1] = status;
                DPRINTF("Card status 0x%02x\n", status);
            }
            s->mode = SSI_SD_RESPONSE;
            s->response_pos = 0;
        } else {
            s->cmdarg[s->arglen++] = val;
        }
        return 0xff;
    case SSI_SD_RESPONSE:
        if (s->stopping) {
            s->stopping = 0;
            return 0xff;
        }
        if (s->response_pos < s->arglen) {
            DPRINTF("Response 0x%02x\n", s->response[s->response_pos]);
            return s->response[s->response_pos++];
        }
        if (sd_data_ready(s->sd)) {
            DPRINTF("Data read\n");
            s->mode = SSI_SD_DATA_START;
        } else {
            DPRINTF("End of command\n");
            s->mode = SSI_SD_CMD;
        }
        return 0xff;
    case SSI_SD_DATA_START:
        DPRINTF("Start read block\n");
        s->mode = SSI_SD_DATA_READ;
        return 0xfe;
    case SSI_SD_DATA_READ:
        val = sd_read_data(s->sd);
        if (!sd_data_ready(s->sd)) {
            DPRINTF("Data read end\n");
            s->mode = SSI_SD_CMD;
        }
        return val;
    }
    /* Should never happen.  */
    return 0xff;
}

static void ssi_sd_save(QEMUFile *f, void *opaque)
{
    SSISlave *ss = SSI_SLAVE(opaque);
    ssi_sd_state *s = (ssi_sd_state *)opaque;
    int i;

    qemu_put_be32(f, s->mode);
    qemu_put_be32(f, s->cmd);
    for (i = 0; i < 4; i++)
        qemu_put_be32(f, s->cmdarg[i]);
    for (i = 0; i < 5; i++)
        qemu_put_be32(f, s->response[i]);
    qemu_put_be32(f, s->arglen);
    qemu_put_be32(f, s->response_pos);
    qemu_put_be32(f, s->stopping);

    qemu_put_be32(f, ss->cs);
}

static int ssi_sd_load(QEMUFile *f, void *opaque, int version_id)
{
    SSISlave *ss = SSI_SLAVE(opaque);
    ssi_sd_state *s = (ssi_sd_state *)opaque;
    int i;

    if (version_id != 1)
        return -EINVAL;

    s->mode = qemu_get_be32(f);
    s->cmd = qemu_get_be32(f);
    for (i = 0; i < 4; i++)
        s->cmdarg[i] = qemu_get_be32(f);
    for (i = 0; i < 5; i++)
        s->response[i] = qemu_get_be32(f);
    s->arglen = qemu_get_be32(f);
    if (s->mode == SSI_SD_CMDARG &&
        (s->arglen < 0 || s->arglen >= ARRAY_SIZE(s->cmdarg))) {
        return -EINVAL;
    }
    s->response_pos = qemu_get_be32(f);
    s->stopping = qemu_get_be32(f);
    if (s->mode == SSI_SD_RESPONSE &&
        (s->response_pos < 0 || s->response_pos >= ARRAY_SIZE(s->response) ||
        (!s->stopping && s->arglen > ARRAY_SIZE(s->response)))) {
        return -EINVAL;
    }

    ss->cs = qemu_get_be32(f);

    return 0;
}

static void ssi_sd_realize(SSISlave *d, Error **errp)
{
    DeviceState *dev = DEVICE(d);
    ssi_sd_state *s = FROM_SSI_SLAVE(ssi_sd_state, d);
    DriveInfo *dinfo;

    s->mode = SSI_SD_CMD;
    /* FIXME use a qdev drive property instead of drive_get_next() */
    dinfo = drive_get_next(IF_SD);
    s->sd = sd_init(dinfo ? blk_by_legacy_dinfo(dinfo) : NULL, true);
    if (s->sd == NULL) {
        error_setg(errp, "Device initialization failed.");
        return;
    }
    register_savevm(dev, "ssi_sd", -1, 1, ssi_sd_save, ssi_sd_load, s);
}

static void ssi_sd_class_init(ObjectClass *klass, void *data)
{
    SSISlaveClass *k = SSI_SLAVE_CLASS(klass);

    k->realize = ssi_sd_realize;
    k->transfer = ssi_sd_transfer;
    k->cs_polarity = SSI_CS_LOW;
}

static const TypeInfo ssi_sd_info = {
    .name          = "ssi-sd",
    .parent        = TYPE_SSI_SLAVE,
    .instance_size = sizeof(ssi_sd_state),
    .class_init    = ssi_sd_class_init,
};

static void ssi_sd_register_types(void)
{
    type_register_static(&ssi_sd_info);
}

type_init(ssi_sd_register_types)