make rtc alatm work

Convert alarm time from BCD if needed before comparing with current
time.

Signed-off-by: Gleb Natapov <gleb@redhat.com>
Signed-off-by: Anthony Liguori <aliguori@us.ibm.com>

hw/mc146818rtc.c

diff --git a/hw/mc146818rtc.c b/hw/mc146818rtc.c
index c3459bf..2b91fa8 100644
--- a/hw/mc146818rtc.c
+++ b/hw/mc146818rtc.c
@@ -214,7 +214,6 @@
         case RTC_SECONDS_ALARM:
         case RTC_MINUTES_ALARM:
         case RTC_HOURS_ALARM:
-            /* XXX: not supported */
             s->cmos_data[s->cmos_index] = data;
             break;
         case RTC_SECONDS:
@@ -414,11 +413,11 @@
     /* check alarm */
     if (s->cmos_data[RTC_REG_B] & REG_B_AIE) {
         if (((s->cmos_data[RTC_SECONDS_ALARM] & 0xc0) == 0xc0 ||
-             s->cmos_data[RTC_SECONDS_ALARM] == s->current_tm.tm_sec) &&
+             rtc_from_bcd(s, s->cmos_data[RTC_SECONDS_ALARM]) == s->current_tm.tm_sec) &&
             ((s->cmos_data[RTC_MINUTES_ALARM] & 0xc0) == 0xc0 ||
-             s->cmos_data[RTC_MINUTES_ALARM] == s->current_tm.tm_mon) &&
+             rtc_from_bcd(s, s->cmos_data[RTC_MINUTES_ALARM]) == s->current_tm.tm_min) &&
             ((s->cmos_data[RTC_HOURS_ALARM] & 0xc0) == 0xc0 ||
-             s->cmos_data[RTC_HOURS_ALARM] == s->current_tm.tm_hour)) {
+             rtc_from_bcd(s, s->cmos_data[RTC_HOURS_ALARM]) == s->current_tm.tm_hour)) {
 
             s->cmos_data[RTC_REG_C] |= 0xa0;
             qemu_irq_raise(s->irq);